| Click to Post a New Message!
Page [ 1 ] |
|
|
irrigation implement
My $0.02,
If you are planning on leaving your tractor un attended, you need to consider installing Murphy Switches (failsafe switches) one switch to monitor engine oil pressure, and another to monitor engine collant temp.
I have farmer customers who use larger tractors to run irigation pumps and these switches have saved many engines.
Just loseing a fan belt for only a few minutes and a overhaul is emminent. Without out the protection these swithes will give you, you would have to remain at the tractor while it is in operation to monitor the gauges.
If it were mine, I would also install a switch in the main sprinkler line , just in case your irrigation pump lost pressure, your tractor will shut down and no fuel is wasted.
I have enough expeirience with irrigation to know the pitfalls.
The "wiggler" is a must, but they have been known to plug.
Also, it takes 27152 gallons of water to put an inch of water on 1 acre.
Last, if you are drawing from a private pond, no problem. But, if you are pumping from a ditch, stream ,or river, check with the authorities. You may need a permit, or it may be completely prohibited. a homeowner near here was just fined $10000 for pumping from the river to water his lawn. Better safe than sorry.
|
|
Add Photo
Bookmarks: |
|
| |
|
Page [ 1 ] | Thread 29715 Filter by Poster: 1 | 1 | 1 | 1 | 1 | 1 | 1 | 5 | 2 | 1 | 3 | 1 |
|
()
Picture of the Day brewdog
Unanswered Questions
Active Subjects
Hot Topics
Featured Suppliers
|